主にマイコンのFAQページです。 PSoC関連†Global Resourcesを変更時に、ブートコード(boot code)が大きくなり、memory area conflictになった場合の対処法 【近藤】†Global Resourcesを変更した場合、以下のようなエラーが出る場合がある。 エラーをクリックすると、overlap.txtが表示される。 This linker error implies there is a memory area conflict. This is typically seen when an absolute code area has grown into a relocatable memory area. The most common symptom for this error comes from the growth of the boot code, due to global parameter changes, encroaching into the start of relocatable code. In this case, you can increase the start of the relocatable start address by changing the value of the address in the Project >> Settings... >> Linker dialog. どうやらブートコードが大きくなり、メモリの衝突が起きた、ということのようだ。 この辺を参考元を参考にしながら、 これで解決。 Thanks! Device Editorのリフレッシュについて【狩野】†仕様みたいなもんですが、Device Editor編集中に 図1:どこにもつながれていない図 図2:仕様画面 このような時は 図3:解決法 簡単かもしれませんが、僕以外にも引っかかった人がいたので。
TIマイコン関連†eZ430-F2013で割り込み制御を行うときの注意【駒村】†タイマなどを使って割り込み制御を行うプログラムを書くと、デバッグモード中だけプログラムが正しくない動作をすることがあります。 |